Dash Pad Restoration Process: A Tour of Just Dashes

Categories

Is your model not here yet?

This is just a sampling. Contact us for Your Free Quote.

This older video gives a tour of our Van Nuys shop and walks through the full dash pad restoration process, one step at a time. It’s a good look at how your collector car dash pads and other trim parts go from cracked and brittle to ready to install again. Here are the nine steps.

Step 1: Inspection and Preparation

When your part arrives, we inspect it and decide how we’re going to repair it. A part in rough shape gets its deteriorated vinyl and foam ground down so we’re working from a sound base.

Step 2: Applying the New Foam

After the old, dried, brittle plastic and foam are removed, we apply new foam. We use a polyethylene closed cell high-density foam, which is much better than what the factory originally used.

Step 3: Hand Shaping

Once the foam is on, the part is hand shaped and sanded to factory specifications so it will fit back in your vehicle the way it should. This is where most of the craftsmanship happens.

Step 4: Applying the Adhesive

Next, we apply an environmentally friendly adhesive. This is what bonds the new vinyl skin to the shaped foam.

Step 5: Applying the Vinyl Skin

With the adhesive on, we use our heat process to apply the new vinyl skin. The vinyl is shaped tightly over the foam so it picks up all the lines and details from the hand shaping step.

Step 6: Trimming and Finishing

After the vinyl is applied, the excess is trimmed at the edges. The edges are then folded over and glued for a clean finish.

Step 7: Applying the Color

From the trimming department, the part goes to color. We apply the correct factory color, or a custom color if that’s what your build calls for.

Step 8: Quality Control Inspection

When the restoration is done, each part is thoroughly inspected by a quality control supervisor before it goes back to the customer.

Step 9: Packaging and Shipping

Finished parts are carefully wrapped and boxed so they arrive safely.

What We Can Restore

We’ve specialized in foam shaping and covering classic car interior parts in new vinyl since 1981. We can restore just about any dash pad from the 1950s through the 1990s, along with other interior trim parts.

How to Get Started

Our four-step process makes sure we have everything we need before your part ships:

  • Get a quote on our website.
  • Send photos for a photo inspection. The instructions come with your quote email.
  • Fill out a packing slip.
  • Box it up and ship your part to our shop in Van Nuys.

Please send your part as it is, without removing any of the old material. If it has already been stripped, send us photos first, since we usually can’t work on stripped dashes.

We look forward to helping with your dream car.

Get a free quote, or send us photos of your dash and we’ll tell you what it needs.

Just Dashes