Last time we showed you our foam department. This time we’re walking through the other half of the job: dash restoration finishing. Once the new vinyl skin has been shaped over the foam, the dash still has to be trimmed, repaired, dyed and detailed before it’s ready to go back in your car. This is where a lot of the real craftsmanship happens.
We restore dashes and interior parts from the late ’50s through the late ’90s, and some from the early 2000s. Every one of them comes through this department.
Trimming and Tucking
When a dash comes out of the forming step, there’s a lot of extra material. The vinyl needs to be trimmed and tucked underneath, and we have technicians who have been doing this for decades.
The factories never expected anyone to rebuild these dashes this way. Originally, the vinyl was shaped in a cavity and the foam was injected behind it, which is a very different process from ours. We use OEM-style dash vinyl, and the high-density foams we use are better than what was in these dashes when they were new.
One side effect of our process is something we call webbing. In tight spots, the vinyl pinches at the edges. Our guys trim that pinch away as closely as possible, then tuck the vinyl behind. What’s left is a very thin gap.
The Invisible Repair
Nobody wants to pull a freshly restored dash out of the box and see trim marks. So we do what we call an invisible repair.
- First, the gap is filled and smoothed so the surface is flat.
- Then a texture putty goes on.
- Finally, we use texture pads that match the different grains to press the original pattern back into the repair.
Some dashes are much harder than others. On deep areas where the vinyl doesn’t draw in well, we hand-trim the whole section, and every one of those seams gets the same repair. Once it comes out of paint, it looks brand new. We don’t settle for a smooth spot. We match the texture so the repair blends with the rest of the dash.
Vinyl Dyeing and Color
We use the terms painting and vinyl dyeing interchangeably. Every dash starts black, and we usually dust it with black to get the flat finish these dashes had from the factory. We can also do reds, greens, or whatever color you need.
Sometimes we recommend leaving the dash unpainted. Our raw material takes paint well. If you’re chasing a tricky color like a Mopar B5 or B7 blue, or a pearl white with three stages, small differences between two painters can throw the hue off. When a dash sits right next to a door panel or upper door trim, we always suggest having the same person, in the same booth, paint the parts together.
Final Detailing
The last stop is our fine detailing bench. This is where every bolt, clip and screw gets attention, including bead-blasted hardware. If our foam department is the engine builder, these are the tuners getting the last bit out of it.
Projects on the Bench
A couple of jobs we were working on during filming:
- A custom VW Bug dash with heavily modified metal for a new round gauge setup
- Interior panels from an ’88 Honda Civic, part of a full interior kit we built for one car
The Civic panels were tough. Honda never built them to be taken apart and rebuilt, so we had to work out how to disassemble and reassemble them properly, using hot welding, staples and whatever else the part needed. Every job is a little different, and that takes time.
Finishing is the part you see and touch every day, which is why we give it as much care as the foam work underneath.
Get a free quote, or send us photos of your dash and we’ll tell you what it needs.