To Go to Part One of "BEEN THERE, WON THAT!", Click Here To Go to Part Two of "BEEN THERE, WON THAT!", Click Here

(Click Here to view a larger photograph) The center section is now positioned on the machine and prepared for the vinyl application. It is supported at all critical areas by wooden blocks so the force of the vacuum pulling down the vinyl doesn't contort the fiberglass. (Click Here to view a larger photograph) The new vinyl is now permanently applied. Notice the rough areas outside the edges of the center section. All this excess is trimmed off when the piece is removed from the machine. Pretty cool!

(Click Here to view a larger photograph) The center section is now hand finished as were the pods. The vinyl will wrap inside all the holes and control slots so your clock and temperature controls will fit right back in, not mention the radio being able to go home again. (Click Here to view a larger photograph) Here is the finished center section with pods attached. As you can see it is perfectly restored and ready to be reinstalled in your Corvette.

(Click Here to view a larger photograph) The fit between the pods and center section is flawless. Notice how clean all the edges have been finished. This is important for a correct fit back into the 'Vette. Too much material might cause unwanted gaps to appear.

Click Here to return to BEEN THERE, WON THAT!, Part One. Click Here to return to BEEN THERE, WON THAT!, Part Two. Click Here to return to the magazine articles listing.